|
WQM&SP under JJM / S.H.: Supplying of Field Testing Kits (FTK) for Chemical & Bacteriological testing of water sample in/c providing & fitting fixing of Laboratory Instruments, Chemicalsand Equipments forSub-Division Level Water Testing Laboratory at Amarpur during the year 2025-26.-Supply of field testing kits (FTK) for chemical parameters like Turbidity, pH, Hardness, Chloride, Iron, Nitrate, Fluoride, Residual Chlorine etc. for conducting at least 100 (one hundred) water sample testing including carrying, loading & unloading as per direction of the Engineer In-Charge. 2 Supply of Laminar Flow Cabinet (Horizontal type)Structure made of complete Stainless Steel sheet-polished. Sides of work bench covered with transparent acrylic sheet. Front acrylic door of collapsible type. Work-bench made of Stainless Steel, working table size – 3ft X 2ft X 2 ft, HEPA Filter provided vertically on back of the work bench horizontally. Blowers, motor and pre-filters fitted in lower portion of the cabinet. Properly balanced blowers should be fitted of 1/4 H.P. Electric motor should be provided to supply sufficient air to HEPA filter. Pre-filters should provided to supply pre-filtered air to the blowers. One fluorescent tube and one U.V. Germicidal tube provided over work bench. Static pressure manometer fitted to the unit. 3 Supply of Microprocessor based digital analytical balance of capacity 210 gm, Readability: 0.1 mg, Standard deviation : ≤ 0.1 mg, Linearity ± 0.2 mg, Response : Approx 3.0 secondInternal Calibration, Air shield. 4 Supply of Vertical Autoclave with outer chamber made of heavy gauge Stainless Steel Sheet duly polished. The inner chamber is made of thick 304 Grade Stainless Steel Sheet. Lid is made of thick machined high grade Stainless Steel plate. The unit has Radial Locking arrangement made of high grade SS duly polished with paddle lifting mechanism. Unit is provided with Spring Loaded Safety Valve, Pressure Gauge, Pressure Release Valve, Water Level Indicator & Drain Valve. Unit is hydraulically tested to withstand upto 40 psi pressure. All internal joints are Argon arc welded, ground and polished to give crevice free internals. Molded joint-less Silicon Rubber Gasket is provided for leak proofing. The unit is electrically heated by flange type/immersion type heaters. Supplied with Control Box, fitted with Mains & Heating Indicators, ON / OFF Switch, Cord & Plug to work on 220/230V, 50Hz, AC supply. Maximum pressure of the steam 15 lbs/sq inch The autoclave should be supplied complete with2.0 KW immersion heater. 5 Supply of Digital Colony Counter ,( 4-Digit Counter, LED Display range 0-9999, Buzzer and marking pen Data restoredeven after power failure) withmagnification lens , electronic power set, power adaptor and instrument manual 6 Supply of Vacuum Desiccator (300mm dia).Should be included with a polypropylene stopcock (PTFE plug) to control airflow and a hose connection with vacuum tubing. The unit should have a neoprene O-ring for a secure seal, which does not require grease. Also, it should come with a rigid, perforated polypropylene plate. Shatter resistant polycarbonate upper section. 7 MacConkey Broth (500 gm) 8 Con. Hydrochloric Acid (500ml) 9 Ammonium Acetate(500 gm) 10 Glacial Acetic Acid (500 ml) 11 Sodium Chloride (500 gm) 12 Brilliant green lactose bile broth (500 gm) 13 Magnesium chloride (500 gm) 14 Potassium Nitrate (500 gm) 15 Sodium acetate (500 gm) 16 Barium chloride (500 gm) 17 Sodium sulphate (500 gm) 18 Murexide (5 gm) 19 Ammonium ferrous sulphate (500 gm) 20 Erichrome ferrous sulphate (500 gm) 21 EDTA salt (100 gm) 22 Iron standard solution traceable to SRM from NIST Fe (NO3)2 in HNO3 0.5 mol/L 1000 mg/L Fe(100 ml=1 unit) 23 Supply of Reagent Bottles, Narrow Mouth, Plain, Made from Heat Resistant, Low Expansion Borosilicate Glass (Capacity 500 ml) 24 Supply of Reagent Bottles, Narrow Mouth, Plain, Made from Heat Resistant, Low Expansion Borosilicate Glass (Capacity 250 ml) 25 Supply of Beaker, with low form, with graduation and Spout, made from Heat resistant, Low expansion Borosilicate Glass (capacity 500 ml) 26 Supply of Pipette with Work Certificate, should Complies with IS, EN ISO 835, Should be supplied with individual calibration certificate showing actual volume dispensed and providing traceability to national standards (Capacity 10 ml) 27 Supply of Pipette with Work Certificate, should Complies with IS, EN ISO 835, Should be supplied with individual calibration certificate showing actual volume dispensed and providing traceability to national standards (Capacity 25 ml) 28 Supply of Test tube with rim and round bottom, complies with IS 2018, ISO / DIN 4142, made from heat resistant, low expansion Borosilicate Glass (Capacity 15 ml) OD x length: 15 x 150 mm) 29 Supply ofVolumetricFlask with interchangeable glass stopper, Accuracy as per class ‘A’, USP, White coloured marking, with individual certificate of Performance and made from Heat resistant, Low expansion Borosilicate Glass (capacity 100 ml) 30 Supply ofVolumetricFlask with interchangeable glass stopper, Accuracy as per class ‘A’, USP, White coloured marking, with individual certificate of Performance and made from Heat resistant, Low expansion Borosilicate Glass (capacity 50 ml) 31 Supply of Measuring Cylinder, with graduated and individual certificate of performance, made from heat resistant, low expansion Borosilicate Glass (Capacity 50 ml) 32 Supply of Measuring Cylinder, with graduated and individual certificate of performance, made from heat resistant, low expansion Borosilicate Glass (Capacity 250 ml) 33 Pipette rack 34 Test tube rack 35 Laboratory thermometer (110 ‘c) 36 Safety shower (Full body with eye shower) 37 Anti vibration table 38 First aid box 39 Sample collection bottle (500 ml) 40 Burette stand 41 Ice box 42 Electric Heater 43 Mortar & Pastle 44 Wash bottle (500 ml) 45 Apron with lab coat. 46 Nitrile Hand gloves
|
