|
1) Replacement Of Garage Doors (Gates) 2 Pcs (Garages):- Dismantling Of Old Wooden Gates With A Frame,- Preparation For Assembly Of New Gates,- Purchase And Assembly Of New Segmental Garage Gates With 230V Drive Adapted,- Gates Remote Service, Min. 4 Pilots Of 2-Channel Pilots (Two Gates From One Remote Control),- Assembly And Connection Of The Key Mounted Switch Min. Ip44 For Closing And Opening The Gate From The Outside, - Assembly And Connection Of A Bell Switch To Open And Closing The Gate From The Inside, - Gate Segments With A Thickness Of At Least 40Mm, - Assembly Of New Photocells - 2 Pcs. Photocells 2.68 X 3.16 M (Dimension Should Be Checked By Nature), - Full Gate Opening Light, - The Gate Is Installed Comprehensively Together With The Programming Of The Gate And Pilot Coding, - The Contracting Authority Will Lead The Electrical Power To The Place Indicated By The Contractor, - Emergency Distribution Of The Drive From The Outside (No Other Entrance To The Room Than Through The Gate), - Gate Equipped With Protecting Protection Before Protecting The Protection Uncontrolled Falling Of The Gate,- A Gate Equipped With A Safety Strip, I.E. An Edge Sensor Sensitive To Pressure,- A Gate Equipped With A Region Seal In The Lower Profile,- Installation Of The Doorst. Purchase And Assembly Of A New Segment Garage Door With 230V Drive Adapted,- Standard Door With A High Threshold- 90 Cm Passage Light, Micro-Cutting Of The Gate Drive At The Door Open, Handle, Lock, Patent Insert,- Remotely Handled Gate, Min 4 Pilots Are Required (Gate Control To Warehouse 1 And Warehouse No. 2 From One Remote Control),- Assembly And Connection Of The Key Mounted Switch Min. Ip44 For Closing And Opening The Gate From The Outside, - Assembly And Connecting The Bell Switch To Open And Close The Gate From The Inside, - Gate Segments With A Thickness Of At Least 40Mm, - Assembly Of New Photocells - 2 Pcs. Photocells 3.96 X 3.47 M (Dimension Should Be Checked By Nature), - Gate Opening Light 3.30 M, - The Gate Is Required Comprehensively Together With The Programming Of The Gate And Pilot Coding, - The Contracting Authority Will Lead The Electrical Supply To The Place Indicated By The Contractor, - The Gate Equipped With Protections Protecting Against Uncontrolled Falling Of The Gate, - A Gate Equipped With A Safety Strip. Edge Sensitive To Pressure, - A Gate Equipped With A Region Gasket In The Bottom Profile, - Threshold Installation. 3) Garage Door (Magazine): - Disassembly Of The Old Wooden Gate With A Frame, - Preparation For Assembly Of A New Door, - Purchase And Assembly Of A New Segmental Garage Door With Adapted 230V Drive Handled Remotely, (Gate Control To Magazine 1 And Magazine 2 From One Remote Control),- Assembly And Connection Of The Key-Mounted Switch Min. Ip44 For Closing And Opening The Gate From The Outside,- Assembly And Connecting The Bell Switch To Open And Close The Gate From The Inside,- Gate Segments With A Thickness Of At Least 40Mm,- Assembly Of
|
