|
Meeting Table 250X1, 50M: Dimensions 250 (Length) X 150 (Width) X 75 (Hight) Cm; Top Made Of 25 Mm Thick Mdf, Superimposed On The Structure, Covered In Smooth Low-Pressure Melamine Laminate, In Crystal Gray Color. Along The Length Of The Table, The Edges Must Be Rounded With A 25 Mm Ergosoft Pvc Finish, In The Same Pattern As The Table; In The Width Of The Table, The Edges Must Be With Edge Tape Of At Least 2.5 Mm Thick In Compliance With Abnt, Fixed Through The Automatic Hot Melt Glue Process; The Top Must Be Fixed To The Structure Using Screws; Front Panel Made From 15 Mm Thick Mdf, 150 Cm Long And 40 Cm High, With The Same Top Finish On All Sides; The Panel Must Be Fixed Between The Structures Feet Using Screws; The Support Of The Top Must Be By Means Of A Foot, Executed In A Vertical Steel Structure, Made In Square Section Profiles Of 40 X 40 Mm, Forming 02 Parallel Columns In The Form Of A Portico, Spaced 120 Mm Apart. Between The Columns There Must Be A Metal Sheet Closure, Fixed On Both Sides; The Gantry Locks Must Be Carried Out As Follows: In The Upper Part – 1/4 30 X 50 Mm, The Piece Being 840 Mm Long; The Locks Must Be Finished With Plastic Tips, At Their Ends And Height-Adjusting Shoes, At The Bottom With 1 Cm In Height, In The Same Color As The Structure; All Metallic Components Must Be Treated With A Degreasing, Pickling And Phosphating Bath; Epoxy-Powder Paint Must Be Applied To All Metallic Components Using The Electrostatic Deposition Process With Polymerization In A Black Oven; The Entire Structure Must Have A Black Finish, A Reference Standard; All Components Made Of Nylon, Polypropylene, Polystyrene And Polyester Must Be Black. With 3 Drawers, 3-Seat Stringers, Steel File Cabinet With 4 Drawers, L-Shaped Table; Top Made Of Mdf With A Minimum Thickness Of 25 Mm, Covered On Both Sides In Smooth Low-Pressure Melamine Laminate, In Crystal Gray Color, With Straight Edges, Topped With Maple Tape With A Minimum Thickness Of 2.5 Mm In Compliance With Abnt, Fixed Using The Automatic “Hot Melt” Glue Process Approximate External Measurements: 160 (Length) 45º In Relation To The Side Parts, Be Straight, With Sufficient Length So That The Keyboard Support Can Be Adapted To Its Lower Part; It Must Be Made With A Retractable Support For Metal Runners (35 Cm Long) And Measures 72 X 31 Cm With Sides Measuring 10 Cm High, Made Of Melamine, Fixed To The Central Part Of The Top, And Must Slide Smoothly; It Must Be Made With A Drawer On Each Side, With A Minimum Thickness Of 12Mm, Measuring 40 Slot And Metallic Slides; The Drawers Must Be Installed In Such A Way As Not To Interfere With The Operation Of The Keyboard Support; The Thickness Of The Mdf Of The Keyboard Support Must Be D
|
