|
Tenders are invited for Supply and Delivery of Renewable Energy Awareness, Demonstration, and Educational Tools 1 LED Light Fixture Up to 40,000 units Above 40,000 units 2 Solar LED Flood Light Up to 250 units Above 250 units 3 Solar Bollard Light (Garden & Pathway Lighting) Up to 50 units Above 50 units 4 Wind Turbine 2 kW Up to 4 units Above 4 units 5 Direct Solar / AC Water Heating System Up to 200 units Above 200 units 6 PV System Monocrystalline Solar 1 LED Light Fixture LED Bulb Technical Specifications LED Chip Technology: Surface Mounted Device (SMD) No filament technology accepted Wattage: 910 W Voltage Range: 220240 V Frequency: 5060 Hz Energy Efficiency Class: A+ Efficacy: 90 lm/W Lifetime: 15,000 hours Color Temperature: 6500 K Color Rendering Index (CRI): 80 Power Factor: 0.5 THD: < 20% Base: E27 Beam Angle: > 90° Operating Temperature: -10 to +45°C Safety Standard: IEC 62741 E/ IEC 62560 IEC 62560 or equivalent international standard Tests: Test certificate from a certified third-party laboratory Warranty: 2 years 2 Solar LED Flood Light Solar-powered LED flood light suitable for outdoor applications, complying with the following minimum specifications: Light output> 4500 lumens Lighting time: Minimum 8 hours continuous operation after full charge Correlated Color Temperature (CCT): 6500K (Cool White) Light source: High-efficiency LED Battery type: Lithium Iron Phosphate (LiFePO) battery, long life and high safety Battery cycle life 2000 cycles Protection rating: IP65 or higher, suitable for outdoor environmental conditions Solar panel: 20 W, High-efficiency photovoltaic panel, corrosion-resistant Controller: Built-in intelligent charge controller with overcharge and deep-discharge protection Housing: Weather-resistant, corrosion-proof material suitable for outdoor use Operating temperature: Suitable for harsh outdoor environments Mounting: Adjustable bracket for wall or pole mounting Warranty: Minimum 4 years manufacturer warranty 12 Brand: Approved manufacturer or equivalent 3 Solar Bollard Light (Garden & Pathway Lighting) Solar -powered bollard light suitable for gardens, parks, and pedestrian pathways, complying with the following minimum specifications: Light output: Not less than 180 lumens Beam angle: 360° uniform light distribution Color temperature: 3000K (Warm White) Light source: High-efficiency LED Solar panel: Integrated high-efficiency solar panel, minimum 3Wp Battery type: Rechargeable Li-Ion battery, 3.7V Lighting time: Minimum 1012 hours continuous operation after full charge Protection rating: Minimum IP54, suitable for outdoor use Housing: Aluminum body, corrosion-resistant, black finish Operating temperature: +5°C to +40°C Mounting: Ground-mounted bollard, suitable for garden and pathway installation Dimensions: Approx. Ø160 × 220 mm or Ø160 × 600 mm Warranty: Minimum 4 years manufacturer warrant 4 Wind Turbine 2 kW Vertical axis wind turbine (VAWT) or approved equivalent, suitable for small-scale renewable energy applications, with the following minimum specifications: Rated power: 2000 W Maximum power: Not less than 2200 W Rated voltage: 1248 V DC Generator type: Three-phase permanent magnet AC synchronous generator Magnet material: NdFeB (Neodymium Iron Boron) Start-up wind speed: 3 m/s Rated wind speed: Approx. 13 m/s Rotor type: Vertical axis, multi-blade design Number of blades: 3 blades Blade material: High-strength nylon fiber, lightweight and corrosion-resistant Rotor diameter: Approx. 530 mm Blade height: Approx. 750 mm Generator housing: Casting aluminum alloy, corrosion-resistant Control system: Intelligent electromagnetic control system Overspeed protection: Electromagnetic brake 13 Overload protection: Electromagnetic braking system with unloading unit Controller and Accessories: Supplied complete with hybrid wind controller suitable for battery charging systems Includes all mounting accessories, bolts, nuts, flanges, brackets, and tools required for installation Compatible with off-grid or hybrid renewable energy systems Installation and Structure: Suitable for installation on pole or tower mounting Designed for safe operation in residential, institutional, and rural environments Low noise and vibration during operation Warranty and Quality: All components shall be new, unused, and factory tested Manufacturer warranty: Minimum 2 years 5 Direct Solar / AC Water Heating System Supply, install, and commission a water heating flange system suitable for domestic water tanks, operating on direct solar power (48 V DC) with 230 V AC backup, complying with the following minimum requirements: Heating element: 900 W immersion heating flange, stainless steel, suitable for potable water Operating voltage: 48 V DC (solar direct) and 230 V AC Switching: Manual AC / OFF / Solar selector switch Cabling & accessories: Complete DC and AC cables, connectors, isolators, and protection devices Safety protection: In addition to the thermostat, the system shall be equipped with an independent thermal sensor (high-temperature cut-off) installed on the hot outlet side of the tank, providing automatic disconnection in case of thermostat failure or overheating System status: All components new, supplied complete, tested, and ready for operation 14 6 PV System PV Modules: High-efficiency monocrystalline PV panels, module efficiency 21%, suitable for rooftop installation. Supply, install, test, and commission PV array modules, each with a capacity of PV module 620 Wp Mounting structure: Corrosion-resistant galvanized steel or aluminum structure System status: All components new, supplied complete, tested, and ready for operation with 5.1 7 Portable Solar Water Pump System with Foldable Solar Panel Portable solar-powered submersible water pump system suitable for wells, ponds, livestock watering, and small irrigation High-efficiency brushless DC motor, rated power 0.25 kW (0.3 HP) with variable speed 7502500 rpm Maximum flow rate: up to 3 m³/hour and maximum head: up to 40 m Helical rotor pump, minimum 100 mm borehole diameter, 26 mm (1 inch) hose outlet, and maximum submersion depth 50 m Supplied with minimum 15 m motor cable, connectors, hose clamp and installation accessories Integrated solar pump controller with MPPT for photovoltaic operation PV input limits: max 55 V DC, 6 A input current, 25 A short-circuit current; maximum continuous system power 250 W Motor drive: 3-phase BLDC PWM with maximum frequency 170 Hz Protection rating: minimum IP68 motor and controller suitable for outdoor operation Operating temperature range: 40°C to +50°C Support for dry-run protection sensor and tank level control switch Wireless monitoring/configuration capability (Bluetooth or equivalent) Supplied with portable foldable solar panel(s) compatible with system voltage limits and sufficient capacity for pump operation 16 8 Portable Solar Water Pump System (Without Solar Panel) Portable solar-powered submersible water pump system suitable for wells, ponds, livestock watering, and small irrigation High-efficiency brushless DC motor, rated power 0.25 kW (0.3 HP) with variable speed 7502500 rpm Maximum flow rate: up to 3 m³/hour and maximum head: up to 40 m Helical rotor pump, minimum 100 mm borehole diameter, 26 mm (1 inch) hose outlet, and maximum submersion depth 50 m Supplied with minimum 15 m motor cable, connectors, hose clamp and installation accessories Integrated solar pump controller with MPPT for photovoltaic operation PV input limits: max 55 V DC, 6 A input current, 25 A short-circuit current; maximum continuous system power 250 W Motor drive: 3-phase BLDC PWM with maximum frequency 170 Hz Protection rating: minimum IP68 motor and controller suitable for outdoor operation Operating temperature range: 40°C to +50°C Support for dry-run protection sensor and tank level control switch Wireless monitoring/configuration capability (Bluetooth or equivalent) Solar panels not included, system must be compatible with standard photovoltaic modules within the specified electrical limits 17 9 Portable Power Station Portable Power Station Technical Specifications (Brand-Specific / Premium-Grade) Battery Capacity: 192 Wh (approx. 60,000 mAh) Battery Chemistry: LiFePO4 (Lithium Iron Phosphate) extended cycle life and enhanced safety compared to conventional lithium batteries Cycle Life: Approx. 3,000 charge cycles AC Output Power: Up to 200 W (continuous, maximum) USB-C Charging (PD 3.1): Up to 140 W bidirectional supports both device charging and station recharging Number of Output Ports: Approx. 5 ports (simultaneous multi-device charging) Solar Input Support: Up to 100 W (compatible with optional solar panel via MC4 or compatible connector) Recharge Speed: Charges to 80% in approximately 1.3 hours via USB-C PD Weight: Approx. 1.9 kg App Connectivity: Smartphone app for battery monitoring and status tracking Compatible Devices: Smartphones, tablets, laptops, LED lighting, and low-to-mid power electronics All units: New, unused, and factory tested Warranty: As per manufacturer standard 18 10 Solar Panel Portable Solar Panel Technical Specifications (Brand-Specific / Premium-Grade) Rated Power Output: 100 W Conversion Efficiency: Up to approx. 23% (monocrystalline solar cells) Adjustable Stand: 4-angle positions (30°, 40°, 50°, and 80°) for optimized sun capture Protection Rating: IP67 (dust-tight and waterproof) Connector Type: MC4 (compatible with Anker PowerHouse series including models 521, 535, and 757, as well as i Tender Link : https://www.jobs.ps/en/tenders
|
