|
Tender for Earth Work In Excavation In Foundation, Trenches Etc. Including Dressing Of Sides And Ramming Of Bottoms, Including Getting Out The Excavated Material, Refilling After Laying Pipe/ Foundation And Disposal Of Surplus Excavated Material At A Lead Upto 50M Suitable Site As Per Direction Of Engineer For Following Depths, Below Natural Ground / Road Top Level. 4.10.1 In All Types Soils/ Saturated Soil Such As Moorum, Sand, Sandy Silt, Clay, Black Cotton Soil, Kankar, Etc. 4.10.1.1 Depth Upto 1.5 M , Providing, Laying And Spreading Of Granular Sub-Base By Providing Coarse Graded Material (Table 400-2), Spreading In Uniform Layers With Motor Grader On Prepared Surface, Mixing By Mix In Place Method With Rotavator At Omc, And Compacting With Vibratory Roller To Achieve The Desired Density, Complete As Per Mort&H Specification Clause - 401 Including All Material, Labour, Machinery, Lighting, Guarding And Maintenance Of Diversion.7.3.3 Grading - Iii Material , Construction Of Embankment With Approved Material Obtained From Borrow Pit With All Lifts And Leads, Transporting To Site, Spreading, Grading To Required Slope And Compacting By Vibratory Roller 8-10 Tonne To Meet Requirement Of Table 300-2 Including Cost Of Compensation For Earth Taken From Private Land Complete As Per Mort&H Specification Clause 305. (Lead Taken Upto 5 Km)(4.4) , Providing And Laying Lean Cement Concrete 1:4:8 In Sub- Base Over A Prepared Sub-Grade With Coarse And Fine Aggregate Conforming To Is: 383, The Size Of Coarse Aggregate Not Exceeding 25 Mm, Aggregate Cement Ratio Not To Exceed 15:1, Aggregate Gradation After Blending To Be As Per Table 600-1, Cement Content Not To Be Less Than 150 Kg/ Cum, Optimum Moisture Content To Be Determined During Trial Length Construction, Concrete Strength Not To Be Less Than 10 Mpa At 7 Days, Mixed In A Batching Plant, Transported To Site, Laid Manually, Compacting With Surface Vibrator, Finishing And Curing Complete As Per Clause 601, 112 Of Mort&H Specification Including All Material, Labour, Machinery, Lighting, Guarding And Maintenance Of Diversion. , Providing And Laying Un-Reinforced, Dowel Jointed, Plain Cement Concrete Mix With Concrete Mixer & Vibrator Pavement Over A Prepared Sub Base With 43 Grade Cement , Coarse And Fine Aggregate Conforming To Is: 383, Maximum Size Of Coarse Aggregate Not Exceeding 25 Mm, Mixed As Per Approved Mix Design, Laid, Spread, Compacted And Finished In A Continuous Operation Including Provision Of Contraction, Expansion, Construction And Longitudinal Joints, Joint Filler, Separation Membrane, Sealant Primer, Joint Sealant, Debonding Strip, Admixtures (If Required) As Approved, Curing Compound, Finishing To Lines And Grades Complete As Per Drawing And As Per Clause 602, 112 Of Mort&H Specification Including All Material, Labour, Machinery, Lighting, Guarding And Maintenance Of Diversion. 9.5.1 Plain Cement Concrete M-20 , 29.2 Structural Steel Work Riveted, Bolted Or Welded In Built Up Sections, Trusses And Framed Work, Including Cutting, Hoisting, Fixing In Position And Applying A Priming Coat Of Approved Steel Primer All Complete: , 31.1 Providing Corrugated G.S. Sheet Roofing Including Vertical/ Curved Surface Fixed With Polymer Coated J Or L Hooks, Bolts And Nuts 8 Mm Diameter With Bitumen And G.I. Limpet Washers Or With G.I. Limpet Washers Filled With White Lead And Including A Coat Of Approved Steel Primer And Two Coats Of Approved Paint On Overlapping Of Sheets Complete Upto Any Pitch In Horizontal/ Vertical Or Curved Surfaces) Excluding The Cost Of Purlins, Rafters And Trusses And Including Cutting To Size And Shape Wherever Required.31.1.3 0.63 Mm Thick With Zinc Coating Not Less Than 275Gm/M² , 30.27 40 Mm Thick Fine Dressed Stone Flooring Over 20 Mm (Average) Thick Base Of Cement Mortar 1:5 ( 1Cement : 5 Coarse Sand) With Joints Finished Flush. , 2587 Polyethylene Water Storage Tank With Cover And Suitable Locking Arrangement , 71.49 Supply, Installation, Testing And Comissioning Of Is:1475 Marked Self Contained Drinking Water Cooler With Hermetically Sealed Compressor,Non Cfc Refrigerent Suitable For Operation On 230V/1Ph/50Hz Ac Supply,Full Stainless Steel (Ss304) Body (0.8 Mm Thick) And Tank (0.5 Mm Thick) , Stainless Steel Water Tray,Minimum Two Nos Brass Chrome Plated Faucets And Suitable Drainage System Complete In All Respect With Required Height Ms Fabricated And Painted Angle Iron Frame (Cost Of Frame To Be Paid Extra) Complete In All Respect Of The Following Capacity. All As Per Pre Approved By Engineer In-Charge. For Additional Technical Parameters Of Products/ Work, Refer Annexure A Attached With This Bsr 71.49.2 Cooling Capacity 60 Ltr./Hr. And Storage Capacity 120 Ltrs , 1202 Stainless Steel Kitchen Sink - With Drain Board 510 X 1040Mm Bowl Depth 225 Mm. , 50.1 Wiring Of Light Point/ Fan Point/ Exhaust Fan Point/ Call Bell Point With 1.5 Sq. Mm Nominal Size Fr Pvc Insulated Unsheathed Flexible Copper Conductor 1.1 Kv Grade And 1.5 Sq. Mm Nominal Size Fr Pvc Insulated Unsheathed Flexible Copper Earth Conductor 1.1 Kv Grade (Is:694) In Recessed Isi Marked Mms ( Is:9537 P - Iii ) Virgin Material Pvc Conduit & Its Isi Marked (Is:3419-1988) Accessories, Round Tiles, 1.2 Mm Thick Hot Dipped Galvanized Modular Box With Earth Terminal, 10A Modular Switch, Modular Face Plate With Grid Plate, 3 Pin Ceiling Rose / Holder /3 Way Connector, Screws, Making Connections, Testing Etc. As Required. For Specification Of Copper Conductor, Phenolic Laminated Sheets & Electrical/ Wiring Accessories Refer Chapter-53, 54 & 56 For Additional Technical Parameters Of Product / Work Refer Annexure A Attached With This Bsr 50.1.1 Short Point (Up To 3 Mtr.) , 64.4 Providing & Fixing Of 1200 Mm Sweep Bldc Technology Power Saving Ceiling Fan Which Can Withstand On Votage Fluctuations From 140 Volts To 240 Volts ,Power Factor Not Less Then 0.9 , Service Value (Cmm/W) Minimun 6.85 , Air Delivery Minimun 220 Cmm, Speed Minimum 330 Rpm ( Tolerance As Per Is:374 2019 ) Thd Less Then 10% And Complete With Down Rod Of 15 Mm Dia. Erw (Electrical Resistance Welded ) Of 1.6Mm Nominal Thick Medium Duty Steel Pipe Up To 80 Cm , Cotter Pin With 3 X 1.5 Sq.Mm Pvc Insulated Flexible Copper Conductor Making Connection Testing Etc. As Required. All As Per Pre Approved By Engineer In-Charge. For Additional Technical Parameters Of Products/ Work , Refer Annexure A Attached With This Bsr . 64.4.1 Without Remote , Providing And Fixing Chlorinated Polyvinyl Chloride (Cpvc) Pipes, Having Thermal Stability For Hot & Cold Water Supply Including All Cpvc Plain & Brass Threaded Fittings I/C Fixing The Pipe With Clamps At 1.00 M Spacing. This Includes Jointing Of Pipes & Fittings With One Step Cpvc Solvent Cement And Testing Of Joints Complete As Per Direction Of Engineer In Charge. Internal Work - Exposed On Wall 20 Mm Dia , 25.1 Random Rubble Masonry With Hard Stone In Foundation And Plinth : 25.1.1 Cement Mortar 1:6 (1 Cement : 6 Coarse Sand) , 32.1 Cement Plastering Including T&P, Scaffolding, Material And Complete Labour, Including Cost Of Water, Curing, Racking Of Joints Etc. With 12 Mm Cement Plaster Of Mix : Including Providing /Mixing Of Synthetic Fibers Compulsorily Complying With Is 16481:2022 Of 06 Mm/12 Mm Length To Be Mixed @ 0.25% By Weight Of Cement I.E. 125 Gms Per 50 Kg Cement Up To 900 Gms Per Cum Of Concrete/ Mortar 32.1.1 1:4 (1 Cement : 4 Fine/ Coarse Sand) , 33.69 Finishing Walls With Acrylic Smooth Exterior Paint Of Required Shade: 33.69.1 Old Work (Two Or More Coat Applied @ 1.67 Ltr/ 10 Sqm) On Existing Cement Paint Surface). , 24.1 Brick Work With Fps Bricks Of Class Designation 75 In Foundation And Plinth In:24.1.2 Cement Mortar 1:6 (1 Cement : 6 Coarse Sand)
|
