|
24 Sheet Steel File: With Minimum Specifications, Made Of Reinforced Steel Sheet, With 4 Drawers For Hanging Folders And Drawer Sliding With 24 Mm Thick Telescope Rail, In Gray Color. It Has 4 Resistant Leveling Feet. Dimensions: Med.Approx.: - File With Minimum Specifications: Made Of Reinforced Steel Sheet, In Gray Color. It Has 4 Resistant Leveling Feet. Dimensions: Approx.: 133 X 0.50 Door, Inverted Locking System That Does Not Require The Use Of Screws, Made Of No. 26 Steel Sheet, With Anti-Rust Treatment Electrostatic Painting, Fully Assembleable, Does Not Require The Use Of Screws, Removable Feet In Polypropylene With High-Impact Level Adjustment In Black, Capacity Per Bay: 20 Kg (Well Distributed), Internal Reinforcement Per Door, Product As Per With Nr-18 And Nr-24 Standards, Handles Stamped On The Door Itself In A Vertical Direction, It Has A Rack System For Adjusting The Shelves Every 50 Mm, 3 Shelves, 01 Of Which Are Fixed Shelves For Locking The Doors And 2 Adjustable Ones, Cylindrical Lock With Yale Type Keys, Measurements: Height: 160 Cm, Width: 75 Cm, Length: 40 Cm, Approximate Weight: 20 Kg., Shelves With Approximate Dimensions 900 To 930 (L) 450(P)X1980 To 2000(H) Mm. All Shelf Components Must Be Made From Sae 1008 To 1012 Steel Sheet, With Columns Made Of Reinforced Steel Sheet Shelf Reinforced Steel Sheet. The Bookcase Must Consist Of 04 Columns With An L-Shaped Section, 35Mm Tabs Perforated At A 50Mm Pitch To Adjust The Height Of The Shelves. Six (06) Removable Shelves That Allow Height Adjustment, Each Shelf Must Have Two Omega Reinforcements, The Front And Back Part Of Each Shelf Must Contain 3 Folds To Provide Greater Resistance And Lower Risk Of Accidents, Minimizing Sharp Edges. The Shelves Will Be Joined To The Columns Using 8 Hexagonal Screws With Nuts. Sides And Bottom With Two Pairs Of Reinforcement Each In The Shape Of An X, With Edges Fixed To The Columns By Screws And Nuts. Metallic Shoes Arranged Individually At The Lower End Of Each Column, Avoiding Direct Contact Of The Steel With The Floor. Anti-Ferruginous Treatment System Using Spray Tunnels Receiving A Layer Of Protection With At Least 3 Steps, Degreasing And Phosphating In Hot Iron Phosphate, Rinsing At Room Temperature And Subsequent Application Of Inorganic Passivator Which Guarantees Phosphate Layers Evenly Distributed Over The Steel And Greater Weather Resistance. The Furniture Must Be Painted Using Continuous Corona-Type Equipment Where It Receives The Application Of Hybrid Powder Paint (Epoxy-Polyester) Using An Electrostatic Adhesion Process With A Textured Finish, With An Average Layer Of 50 Microns. Polymerization Must Take Place In Ovens With The Piece Reaching A Minimum Of 200º C For A Period Of 10 Minutes Or More, Thus Ensuring Total Polymerization Of The Film, Greater Adhesion And Resistance To Wear Of The Final Finish Of The Product. Distortions, Dents Will Not Be Permitted In The Manufacture Or Use Of Sheets By Means Of
|
