|
Carbon Steel Rack Grid Driven Through Motor-Reduction Assembly Using Degremont 2 Type Sprockets, Width 1400 Mm, Power Of 1.5 Hp, Opening Of 15 Mm. Preliminary Technical Specifications: Mechanized Set For Removing Solid Materials, Made Of Carbon Steel. Solids. Dead Plate Mounted On The Side Guides Of The Machine, The Plate Prevents The Solids Removed By The Rake From Falling After The Fixed Grid. The Plate Occupies The Space Between The Top Of The Fixed Grid And The Discharge Point For The Removed Solids. Side Flaps Prevent Debris From Falling Over The Sides And Also Promote Greater Resistance To The Piece.Sill Plate - For Positioning The Fixed Grid.Cleaning Mechanism - Consisting Of A Driving Assembly And Rake, Working Together Along Guides Through A Rack Gear And Sprocket Wheels. Drive Composed Of A Gear Motor That Directly Drives The Toothed Wheels, Which Run Through The Racks On The Side Guides In A Closed And Continuous Cycle Throughout The Entire Working Perimeter. Electric Motor, Three-Phase, With Magnetic Brake 380V, 60Hz, Insulation Class F, Ipw-55 Protection., Belt Conveyor 24 Truss, Dimensioned To Support, Without Any Compromise, The Conveyor Components, And The Operational Efforts And Loads. The Structure Will Have Fixed Supports To Support The Assembly To The Floor; Drive Drum - With A Suitable Diameter For The Operation Of The Equipment And Special Machining For Self-Alignment Of The Belt, Manufactured With Carbon Steel With Ribbed Rubber To Prevent Slipping And Wear Of The Belt; Drive - The Drive Unit Will Be Composed Of A Helical Gear Reducer In Cast Iron Housing, Oil Bath Lubrication, Suitable For Working Continuously/Intermittently, Service Factor Greater Than 2.0, Drawn And Machined Carbon Steel Shafts, Asynchronous Induction Electric Motor, With Cage Rotor, Up To 1. 0 Hp, 220/380 V, 60 Hz, Iv Poles, Totally Enclosed With External Ventilation, Ipw-55 Protection, Class F Insulation. The Belt Operating Speed Will Not Exceed 10 M/Min; Device; Flow Of Liquids And Liquefied Gases. The Equipment Uses External Surface-Mounted Ultrasonic Transducers, Allowing Non-Intrusive Measurement In Fully Filled Tubes, Without Direct Contact With The Fluid. The System Consists Of An Electronic Unit And Ultrasonic Transducers, With Two Pairs Of Sensors Sufficient To Meet The Usual Pipe Diameter Ranges. The Device May Have An Optional Function For Measuring Thermal Energy, Enabling A Complete Analysis Of Consumption And Energy Efficiency In Hydraulic Installations And Air Conditioning Systems. The Meter Is Suitable For Applications
|
