|
Lot 1 - Teacher Set With Fixed Chair At Table: Features A Modular Top Made Of Injected Engineering Plastic That Must Be Fixed To The Structure Using 4 Fittings On The Sides Of The Table (2 On Each Side) And 4 Screws. It Has A 650X250mm Thigh Cover Made Of 15Mm Thick Mdp Covered With White Melamine Laminate, Fixed To The Front Of The Table Using 4 Superb Screws. After Assembled, The Table Should Measure 620X820mm And Be 760Mm High. The Structure Must Be Formed By A Frame Made Of 1010/1020 Steel Tube Of Section 20X40mm With 1.2Mm Composed Of 3 Crossbeams And 2 Headboards. In The Four Corners Of The Frame, In The Lower Part There Must Be A 1010/1020 Steel Cone Where The Table Legs Will Be Mounted. This Cone Must Be Manufactured In A Ø 2” Tube With 2.25Mm Of Wall And Internally Receive A Conical And Expandable Plastic Bushing That Should Fix The Legs Without The Use Of Screws. The Legs Must Be Manufactured In Steel Tube 1010/1020 Ø 1.1/2” At The Lower End Of Each Foot There Must Be A Shoe With Height Adjustment For Leveling The Table, Made Of Polypropylene. All Metal Parts That Make Up The Table Must Receive Anti-Corrosion Treatment And Epoxy Paint. The Chair Must Be Composed Of: Metal Structure, Seat, Back, Tips, Shoes And Plastic Fasteners, And Two Screws. The Seat Must Be Made Of Injected And Anatomically Molded Polypropylene Copolymer With A Textured Finish And Have Dimensions Of 400 Mm Wide, 420 Mm Deep, 4 Mm Wall Thickness With Rounded Corners, Mounted To The Structure By Means Of A Fitting Throughout The Base Tube At The Front Of The Chair And 2 (Two) Cavities Reinforced With 2 Mm Thick Fins, Which Accommodate Self-Tapping Screws For Plastic With A Diameter Of 5X25 Mm And Phillips Slot. On The Front Part, Which Is In Contact With The Users Legs, It Must Be Provided With A Rounded Edge With A Radius So As Not To Obstruct Circulation. Nbr 14006 - School Furniture Chairs And Tables For Individual Student Set. Individual Table With Injected Plastic Top With Application Of Melamine Laminate On The Top Face, Equipped With Technical Injected Structural Cross, Mounted On A Tubular Structure Containing Plastic Book Holders Individual Stackable Chair With Back In Molded Anatomical Plywood Polypropylene, Tubular Steel Structure. Constituents (In Plastic, Steel, Injected Seat And Injected Or Mounted On A Table: Top In Abs (Acrylonitrile Butadiene Styrene), Virgin, Free Of Mineral Fillers, Injected In Blue (See References), Equipped With Nuts With Flange Or Recess, With Coin-Injected Metric Thread And Structural Cross Member In Nylon (Polyamide) With Added Fiberglass, Injected In Black, Laminated Application. High-Pressure Melamine, 0.8Mm Thick, Textured Finish, In Gray Color (See References), On The Top Surface Of The Top, Glued With Two-Component Adhesive Finished Dimensions 608Mm (Width) Depth +/- 1Mm For Height. Design, Detailing And Finishing According To The Project.
|
