Bids Are Invited For Acquisition Of School Furniture To Meet The Demands Of The Municipal Education Units Of ... in Brazil

Work Detail

Table Top Injected In Abs Resin, Smooth, Measuring Approximately 1200Mm Front Panel Made From 15 Mm Multi-Laminated Plywood, Covered In White Formica With Pvc Finish, Fixed To The Structure Using 4 Screws. Top Base Formed By A Curved Steel Tube Around The Entire Lower Perimeter Of The Top, 02 Side Vertical Columns Connecting The Top To The Feet In Oblong Tubes Measuring Approximately 77Mm X 40Mm With A Minimum Thickness Of 1.2Mm. Base Of The Feet In Oblong Tubes Measuring Approximately 20Mm X 48Mm With A Thickness Of 1.5Mm In The Shape Of An Arc. Non-Slip Calendered Shoes Wrapping The Ends Of The Tubes That Make Up The Feet, Performing The Function Of Paint Protection, Increasing Durability, Follow The Shape Of The Arched Feet, Measuring Approximately 53Mm X 162Mm And 53Mm Virgin, Which Can Be Injected In The Same Color As The Top And Attached To The Structure Using A Screw. Chair With Seat And Back In Polypropylene. Seat With Minimum Measurements 400Mm X 460Mm (+/-5%), Seat/Floor Height Approximately 460Mm Without Holes Fixed By Means Of Screws. Backrest With Minimum Measurements 400Mm Seat Base And Connection To The Back In Oblong Tube 16Mm X 30Mm, Covered By The Backrest, A Horizontal Bar For Support Under The Seat In 5/8 Tube. Reinforced Structure With Feet And 02 Side Columns In Plastic Material, Preventing Corrosion And Wear. An Oblong Horizontal Reinforcement Bar Measuring 16Mm The Entire Metal Structure Is Made Of Industrial Steel Tubes Treated With Sets Of Chemical Baths For The Protection And Longevity Of The Structure And The Sun, A Table With A Square Top Made Of Abs Resin, Measuring Approximately 800X800mm For Collective And Non-Individual Use. Top In Injected Abs Thermoplastic Resin, Double Edges Measuring 30Mm Wide With A Minimum Thickness Of 4Mm On The Outer Edge And A Minimum Thickness Of 3Mm On The Inner Edge And On The Ribs That Connect Each Other. Top/Floor Height 590Mm. Table Base Made Of Tube Measuring Approximately 20Mm 2 Thick, With Injected Polypropylene Tips. The Entire Metal Structure Is Made Of Industrial Steel Tube Treated By Sets Of Chemical Baths For Protection And Longevity Of The Structure And Welded Using The Mig System. Manufacturer Injected In Self-Relief Must Be On The Backrest. Seat With Minimum Measurements Of 340Mm Metallicmade Of Industrial Steel Tube Treated By Sets Of Chemical Baths For Protection And Longevity Of The Structure

Contact Information