|
Lot 1 - Tray With 6 Stainless Steel Divisions For Meals, Stackable And Easy To Clean, Dimensions 400Mmx0.66Mm, Lot 1 - Deep Stainless Steel Dish For Meals, Easy To Clean, Diameter 22 Cm, Lot 1 - Stainless Steel Cup With Handle, Capacity Of 200 Ml, Lot 1 - Stainless Steel Meal Soup Spoon, Lot 1 - Stainless Steel Meal Fork, 05/12/2025 - 11:54:23, Lot 1 - Stainless Steel Meal Knife With Rounded Tip, Lot 1 - Stackable And Easy Plastic Tray Cleaning, Dimensions 48 Cm Top: Must Be Injected In Abs Thermoplastic And Have A 0.8M High-Pressure Melamine Laminate On Its Upper Surface, In Gray Color, Glued With Bi-Component Adhesive. On One Of Its Sides It Must Have Two Couplings That Perform The “Connect” Function, Fitted To The Lateral Ends Of The Tables With The Aim Of Connecting One Table To Another When Placed Side By Side, Together With A Total Of 4 Tables. It Must Present The Approximate Measurements Of 3204Mm X 801Mm X 590Mm. Chairs: The Set Must Have 8 Chairs. It Must Be Produced In Engineering Thermoplastic (Polypro-Pylene Copolymer) With Added Glass Fiber, Without Toxic Elements. It Must Follow The Monoblock Construction Concept, Where All The Parts That Must Make Up The Product, Such As The Back, Seat And Feet, Must Be Produced Through A Single Injection Cycle, Making It Robust And At The Same Time Light And Easy To Handle. Must Be Stackable Into At Least Eight Units. The Feet Must Have A “V” Construction And Originate Close To The Central Region Of The Seat. The Lower End Of The Feet Must Receive Shoes, Which Must Be Manufactured In Rsn Hytrel, In Order To Avoid Direct Contact Between The Feet And The Support Surface. It Must Have The Following Approximate Dimensions: Backrest: 333 Mm Wide X 242 Mm High; Seat: 415Mm Wide X 272Mm Deep. Height From Seat To Floor: 363Mm., Lot 2 - Dining Room Set 08 Adult Seats Table With Single Seamless Top Measuring 2150Mm In Length By 950Mm In Width, With A Thickness Of 8Mm And Seamless Edge Measuring 50Mm Made From High Impact Abs Thermoplastic Resin Virgin, Free From Mineral Fillers, Manufacturers Logo Injected Onto The Surface Of The Top. Top Fixed To The Structure Using Screws. Top To Floor Height Of 760Mm. Table Top Base Formed By Two Square Tubes Measuring 25X25mm Positioned Under The Table Top, Manufactured Using The Process Of Mechanical Conformation By Folding, Covering The Entire Perimeter Of The Table, Resulting In Two Welding Points And A Horizontal Support Bar Made Of 25X25mm Tube, 4 Columns With 2Inch Tube For The Feet, With Injected Pp (Polypropylene) Plastic Resin Tips. The Entire Metal Structure Is Made Of Carbon Steel Tube Treated By Sets Of Chemical Baths For Protection And Longevity Of The Structure And Welded Using The Mig System. Width By 300Mm Of Vertical Extension And The Seat Is Approximately 400Mm Wide By 460Mm Deep, Both Components Mounted On A Tubular Carbon Steel Structure, Produced In Tubes That Form The Base Of The Seat, Backrest And The Connecting Bars In 7/8” Tube. Reinforcement
|
