|
Compact Traditional Republican Model Post. Post Made Of Cast Aluminum And Carbon Steel With A Height Of 3,760 Mm With An Ornamental Base In Cast Aluminum, Fixing Discs For Ceiling Lights In Cast Aluminum With Support For Led Lights With A Power Of 80 Watts To 150 Watts. Cast Aluminum Spire, Fluted Conical Post Body In Galvanized Carbon Steel Sheet, 0.65 Thickness With Support Creases For Mechanical Resistance, Length Of 2 Meters. Internal Post Fixation System, Using Internal Fixation Rods In Threaded Drawn Carbon Steel In Measurements Of 3080Mm, With Electrolytic Zinc Plating Treatment; Ground Fixing Anchors In Threaded Carbon Steel, With Electrolytic Zinc Plating Treatment. Post With Electrostatic Polyester Powder Paint In Petroleum Green Color Polymerized At 220°C, Cast Aluminum Ceiling Light Fixing Discs With Support For 01 Led Diffuser With Power From 80 Watts To 150 Watts. Cast Aluminum Spire, Fluted Conical Post Body In Galvanized Carbon Steel Sheet, 0.65 Thickness With Support Creases For Mechanical Resistance, Length Of 3 Meters. Internal Post Fixing System, With Electrolytic Zinc Plating Treatment; Ground Anchors Made Of Threaded Carbon Steel, With Electrolytic Zinc Plating Treatment. Post With Electrostatic Polyester Powder Painting In Petroleum Green Color Polymerized At 220°C., Ornamental Lamp Republican Model In 150 Watt Led. Luminaire Must Be Compatible With Republican Posts Of 01(One), 02(Two), 03(Three) And 05(Five), Luminaires. Installable At Heights From 3500Mm To 5000Mm. The Coupling For Fixing The Luminaire To The Post Must Be Between 180Mm And 220Mm. It Must Have A Belt, Spire, And Ornamental Medal, Painted In Green. The Optical Set Must Have Translucent Lenses For Distributing The Light Beams, Made Of Heat-Resistant Polymers With Anti-Yellowing Additives. This Lens(Es) Must Be Fixed With Weather-Resistant Screws, Fitted Lenses, Quick-Close Lenses, Or Clips Will Not Be Accepted As These May Lose Pressure And Warp Over Time And Use. Closed Luminaires With Conventional Diffusers With A Milky Appearance, Which Limit The Luminous Beams, Will Not Be Accepted. It Must Be Made Of Aluminum. The Entire Luminaire Must Have A Painting Treatment And Must Be Up To 150 Watts With A Luminous Efficiency Of At Least 115 Lumens Per Watt And A Minimum Total Luminous Flux Of 17,250 Lumens. This Luminous Flux Must Be Proven By Presenting A Test Report Lm-79, (Illuminating Engineering Society. Ies Lm 79-08-Electrical And Photometric Measurements Of Solid State Lighting Products) Attested By A Laboratory Accredited By Inmetro, Only Luminaires With Leds In Smo Mounting Will Be Accepted, The Power Supplies (Drivers) Must Be Constant Current With Input Voltage 205 To 240V, Only Luminaires With An Individual Driver (Off Board) Will Be Accepted. The Luminaire Must Have A Protection Device Against Electrical Surges (Dps), Of At Least 10Ka-10Kv, Standardized In Accordance With Iec 61643-11-2011. Only Individual Dps Will Be Allowed, Separate From The Power Supply (Off Board). The Housing Of Electronic Components Must Have A Degree Of Protection Against The Entry Of Dust And Water Residues - Ip-66 And Protection Against Mechanical Impacts - Ik-O?, Public Lighting With Led C Technology
|
