Tenders Are Invited For Chassis Bodies – Delivery Of A Pollutant Box Body in Germany

Work Detail

Chassis Bodies – Delivery Of A Pollutant Box Body. Box Body Suitable For The Described Chassis With A Wheelbase Of 5360Mm, See Document Atego 1527 L4x2 V 08; Box Body In Aluminum Clamp Construction So That Individual Segments Can Be Replaced In The Event Of Repairs; Box Body Painted In Communal Orange, Based On Ral 2011; Internal Suitcase Dimensions: Length Approx. 7200 Mm, Width At Least 2450 Mm, Height Approx. 2100 Mm; Heavy-Duty Cage Reinforcement Of The Box Body. Frames Made Of Rectangular Tubes Must Be Embedded In The Inside Of The Wall. Tunnel-Shaped Construction, Galvanized Profiles. Arrangement Every 600 Mm. Permitted Lashing Loads 2,000 N Per Section, Regardless Of The Lashing Height! Lashing Points In The Area Of ​​The Heavy-Duty Cage Reinforcement Must Be Color-Coded. Side Walls Front Wall Made Of Aluminum Sheet, 1Mm Thick; Pallet Rear Frame; Case Base Made Of 30Mm Multi-Layer Base Plates; 2 Light Strips Incorporated Into The Trunk Roof; Interior Paneling Covered With Aluminum Sheet, Except For The Roof Paneling; 3 Rows Of Lashing Strips, Placed On The Side Wall Paneling. Height Of The Loading Area Floor - Center Of Lashing Strips 400 Mm / 800 Mm / 1,200 Mm, Lashing Strips On The Side Walls And The Front Wall. Airliner Version; 3 Rows Of Airliner Lashing Strips Embedded In The Floor, One Each On The Left And Right Outside And In The Middle; Aluminum Checker Plate On The Side And Front, From The Ground Up To Approx. 1500Mm, Material 3.5 By 5 Mm; Climb Handle With Rear Right Handle; Forced Ventilation Of The Box Body, Ventilation Grille In The Bulkhead At The Bottom And Rear Of The Box Body At The Top, Inner Grille; Skirting Board 300 Mm X 2 Mm; Rail For Collecting And Securing Tension Straps Mounted In The Rear Area; Markings Of The Reinforcement Points In The Rail System In Red; 5 Pieces Of Telescopic Locking Rods With Holder On The Side Of The Case On The Left, Fastening Height Of The Top Rod Measured Approx. 1,800 Mm From The Ground; Tail Lift Made Of Aluminum, Lifting Capacity 2,000Kg, Ergonomic Switch On The Dashboard, In Vehicle-Specific Design; 2,200 Mm Platform Height, Tail Lift Must Completely Close The Rear Part Of The Case. Tail Lift Height Approx. 2,300 Mm, The Rear Area Of ​​The Case Must Be Completely Closed By A Tail Lift. Tail Lift With Ggvs Equipment; Tail Lift With Roll-Back Protection; With Mechanical Support Device; 2 Lifting And Tilting Cylinders Each; 2 Pieces Warning Lights/Warning Flags; Safety Controls With Hand And Foot Controls; Manual Control Panel Integrated Into The Body On The Right Side, Height From The Road Surface Approx. 1,000 Mm; Painting The Tail Lift In Communal Orange Ral 2011 Or Comparable; Completed Test Book; The Following Ventilation Is Used To Ventilate The Body Before Opening The Body Tail Lift. To Do This, The Fans Must Be Switched On From The Drivers Cab. The Design Of The Fans Must Be Chosen So That The Structure Is Completely Ventilated After A Short Time. The Vehicle Batteries Must Be Protected By Undervoltage Protection. Switch-On Time Approx. 10 Min; 2 Electric Fans In Ex Version, 230 Vol

Contact Information