Contract Award For Germany-Freiburg Im Breisgau: Engineering Design Services For The Const...

Contract Award Notice

Work Detail

Contract Award For Germany-Freiburg im Breisgau: Engineering design services for the construction of civil engineering works
As part of the construction of the containment chamber Breisach / Burkheim the following engineering structures must be established for these buildings is the project planning in accordance with § 43 HOAI as well as the technical equipment in accordance with § 55 HOAI investment group power installations each fully in the work phases 5-9 to provide the current draft plan is to Check and where necessary to update the site construction supervision of civil engineering structures is as a special service to be rendered basic of plans are laid down in the plan approval the plans for plan approval are available at the following website: http: vofistwde / VV_IRP / RHRBB_Info_VgVhtmlEs are three screw pump works in the flood dam III or to integrate the back dam When operating the containment chamber, the pumping stations drain the domestic side ditch or Vorflutsystem the three pumping stations guarantee that a holding water level is maintained through this held water level have the trenches a Drainie Rende function the additional defective-making groundwater increases in the agricultural crops and local documents verhindertDie pumping stations each have four screws, which can be switched on switched off or to prevent frequent switching on and off, the screw speed should be regulated by a frequency converter, the design, supply and installation of screw pumps has already been awarded to the firm Landustrie interfaces are the design of the LV be taken of completion of the documents to tender for the construction of three pumping stations: 30082022Fertigstellung engineering of three pumping stations: successively to 30092023Der retention space is flooded by a central three spacious intake structure in the Rhine dam, the inlet cross-section is 63 sqm, 3 x 7.0 m in width and 3.0 m in height following planning services are to be provided: acquisition of the requirements of the plan approval for the buildings and tuning the planning with the competent authority nGestaltung the inlet region between Rhine-km 228.720 and Rhine km 228,830Sohl- and slope protection in the entry and exit areas of the building (flow range: transition to already created Flutgraben) connecting the inlet placed outside the outstretched electricity and communications network interconnection point to the superior part of the guiding and electrical forms a distribution cabinet object plan for the reinforced concrete masonry construction according to the present plans adjustments in coordination with the structural design (including shoring) the structural design is formed by a separate commission provided the structure consists of the lead-in area, a contactor shaft, said passage tunnel and the lead-out area, two-sided baffles and a negative threshold for the improvement of energy conversion the shoring forms a sheet pile wall with back anchoring completion of the documents to tender for the construction of the intake structure: 30122023Fertigstellung Engineering Einlassbauwer k: 30122025Die two buildings BW 5016 and BW 5017 provide regulation structures in the vicinity of the inlet trench constitutes These buildings are are before removing the inlet trench to errichtetenDie requirements of the plan approval process to consider the implementation planning for the years 2022/23 pre-see of completion of the documents to tender for the construction of the regulation structures 5016 5017: 30122022Fertigstellung the two regulating structures 5016 5017: 30122023Vorlage all the audited accounts, documents and evidence: 31,032,026

Key Dates

Contact Information