Autoclave 250 Liter Horizontal Autoclave At High Temperature Steam For Sterilization Of Health Products With Integrated Steam Generator And Feature Structure In Anticorrosive Material. Construction Features With Data Printer; Rectangular Internal Chamber With A Minimum Capacity Of 250 Liters; Sterilization Chambers: The Sterilizer Must Be Built With 2 Chambers, The Internal Chamber Being Made Of High Quality 316L Stainless Steel, With Internal Surfaces With Low Roughness And Rounded Edges, In Order To Prevent The Accumulation Of Dirt And Facilitate Cleaning. And The External Chamber Is Made Of 316L Stainless Steel, Sanitary Polished. The Internal Chamber Must Have Stainless Tubular Rails Where The Transport Cart Rails Will Fit For Easy Sliding Of The Racks Or The Sliding Of Racks Without Rails Into The Internal Chamber; The Camera Assembly Must Be Mounted On A Frame With Anti-Corrosion Protection, With Casters Provided, For Easier Moving In Internal Areas; The Entire Front Of The Autoclave Must Be Made Of Stainless Steel Sheets, With At Least A Brushed Finish; It Must Allow Access For Maintenance On The Front And On One Of The Sides, Thus Being Able To Lean One Side Against The Wall. The Lower Surface Of The Internal Chamber Shall Converge Towards A Central Drain, Protected Against Debris Blockage By A Stainless Steel Fine Mesh Filter. The Internal Chamber Must Be Provided With At A Minimum A 1/2 Inch Thread Connection For Vacuum/Pressure Gauge (Pt) And A 1 Inch Connection For Test Sensor (Tt). (Other Specifications Contained In The Preliminary Technical Study And Term Of Reference), Autoclave 520 Liters Horizontal Saturated And Electric Steam Sterilizer, Pulsating Vacuum, With Vacuum Pump Of At Least 4 Hp, Used For Sterilization And Drying Of Instruments, Porous Materials Packaged Or Not, Fabrics, Gloves, Liquids, Glassware , Baby Bottles, Syringes, Rubbers And Sensitive Materials Such As Optics, With An Internal Chamber Capacity Of At Least 520 Liters. Automatic, Electric, 220V Or 380V - Three-Phase. It Works With A Pulsating Pre-Vacuum Cycle To Remove Air, With 2 Chambers, The Internal One Being Made Of Aisi 316 Stainless Steel, With A Thickness Of 8.00 Mm And The External One Made Of Aisi 304 Or Aisi 316 Stainless Steel, Sanitary Polished. The Chambers Must Be Insulated To Avoid Heat Dispersion, With Perfect Insulation. Own Steam Generator, Coupled To The Chamber, Made Of Aisi 304 Stainless Steel With Resistance Heating, Made Of Stainless Steel. Internal Chamber With Drain According To Technical Standard, Must Have Independent Entry For 1” Validation Glove. Clean Air Inlet For Vacuum Breaking. With Stainless Steel Hydraulic Pipes. Equipment To Be Mounted On A Structure With Adjustable Feet For Leveling It, Made Of Painted Sae 1020 Steel, With A Fitting System On The Sides – Plating Made Of Stainless Steel. It Must Have 02 Doors, By Vertical Lifting - Guillotine Type, With An Automatic Door Opening And Closing System Using An Electromechanical Mechanism, Driven Through Gear Motors, Not Requiring External Compressed Air To Close The Doors, For Greater Gains In Usable Area. Anti-Pinch With Or Without Photoelectric Device Against Obstructions. Automatic Automatic Trap System. Microprocessed Panel - Color Screen – Touchscreen For
|