|
1. The Subject Of The Order Is The Implementation Of The Task Entitled: Construction Of A Multi-Functional Building In Wierzawice - Nursery And Senior Club In The Design And Build System.2. The Scope Of Work Under The Above-Mentioned Task Includes In Particular: 1) Development Of Design Documentation For The Construction Of A Nursery Building And A Senior Club Along With The Necessary Infrastructure, In Particular: Construction Design, Executive Design Covering All Industries, 2) Preparation Of Documents Needed To Obtain A Building Permit Along With With Obtaining A Final Building Permit Decision. Within 7 Days From The Date Of Obtaining The Building Permit Decision, The Contractor Will Provide The Ordering Party With A Complete Set Of Design Documentation, In Particular: Construction Design, Including: Land Development Design And Architectural And Construction Design (Original Or Photocopy Of The Design Documentation Stamped By The District Office In Lezajsk), Technical Design , Detailed Design, 3) Registration Of The Construction Log, 4) Execution Of Works, Including: A) General Construction Works: Preparatory And Earthworks, Concrete Works, Brickwork Made Of Ceramic Hollow Bricks/Cellular Concrete, Roof Structure And Covering, Insulation, Floors, Base Layers, Internal Plasters And Cladding, Window And Door Joinery, Other Works, Installation Of A Passenger Lift, Façade, Land Development, B) Connection Works: Water Supply Connection, Sanitary Sewage Connection C) Sanitary Installations: - Cold And Hot Water Installation With Circulation, - Sanitary Sewage System, - Drainage Of Rainwater From The Roof Slope And Paved Area To The Rainwater Sewage System, - Central Heating Installation, - Fire Protection Installation. (If Required), - Mechanical Ventilation Installation With Heat Recovery (Separate Installation For Each Floor), - Cooling Installation (Separate Installation For Each Floor), - Solar Installation, - Gas Installation, Gas Boiler Room, Gas Detection (If Required), D) Electrical Installations: - Electrical Installation Of Internal And External Lighting, Plug Sockets, Evacuation And Emergency Lighting, - Telecommunications/Multimedia Installation (Projector With Screen, Lan Internet), - Lightning Protection Installation, - Photovoltaic Installation, - Installation Of Equalizing Connections, - Video Intercom Installation, Anti-Burglary Installation, Video Monitoring Installation, Smoke Exhaust Installation (If Required), Dvb-T, Dvb-S Television Installation,5) Submitting A Notification About The Intended Date Of Commencement Of Construction Works To The District Construction Supervision Inspectorate,6 ) Preparation Of Documentation Necessary To Complete Construction,7) Obtaining An Occupancy Permit/Notification Of Construction Completion On Behalf Of The Ordering Party.3. Adaptation Of The Building To The Needs Of Disabled People. The Building Should Be Adapted For People With Various Types Of Disabilities, Taking Into Account The Needs Resulting From Particular Types Of Disabilities. The Building Should Provide Access To The Building For Disabled People Through The Main Entrance Directly From The Area Adjacent To The Building, With Threshold-Free Passage Between Rooms, A Toilet For Disabled People, Installation Of Doors To Public Rooms With A Width Of Min. 90 Cm In The Clear View Of The Open Leaf. A Passenger Lift Will Be Installed In The Building To Enable Disabled People To Move Between Floors.4. Requirements Regarding Facilities For Disabled People: • Around The Main Entrance, People With Disabilities Should Be Able To Move Freely, I.E., Before And After Entering, There Should Be A Space For Maneuver Of At Least 150 X 150 Cm, • The Surface In Front Of The Main Entrance Should Be Hardened And Flattened , And Its Longitudinal Inclination Cannot Be Greater Than 5%, • Install Thresholds With A Maximum Height Of 2 Cm, With A Cut Wedge, • When Installing The Door, Leave At Least 9 Cm Of Free Space On The Side Of The Hinges, • Entrance Door Details: Upper Edge Handle, Lock And Bell Should Be Installed No Higher Than 120 Cm From The Floor Level, - Glass Doors (External And Internal) Must Be Marked With A Contrasting Element - At Least In The Form Of A Yellow Stripe Approximately 20 Cm Wide, Glued Across The Entire Width Of The Door Leaf At A Height Of Approximately 160 Cm ,• Install A Typhlographic Plan Showing The General Plan Of The Building With The You Are Here Point Marked In Plastic - 1 Set,• Install A Description At Each Entrance To The Room, I.E. Number And Its Function, Using Large And Contrasting Signs And With A Description In Braille A,• The Colors Of The Tiles Of The Communication Routes Should Be Made In Such A Way As To Emphasize The Main Directions Of Movement, Marking Various Functional Areas,• The Surfaces Of The Pedestrian Routes Should Be Made Of Anti-Slip Materials,• The Colors Of The Wall And Floor Surfaces Should Be Contrasted, And If This Is Not Possible, Install Strips Skirting Boards Or Plinths In A Contrasting Color. The Use Of Patterns That Are Transverse To The Direction Of Movement Should Be Limited. • Mark Emergency Doors With A Contrasting Element - At Least In The Form Of A Yellow Stripe, • Parking Spaces For Cars Of People With Disabilities Should Be Made Of Concrete Cubes With Unbevelled Edges With A Longitudinal And Transverse Slope, Parking Spaces For People With Disabilities Must Be Connected To The Nearest Sidewalk, • Marking Of The Stalls Intended For Parking Vehicles Transporting People With Disabilities Should Be Made As Follows: A Vertical Sign Called An Envelope (D-18A With The T-29 Plate And A Horizontal Sign P-20 With The P-24 Symbol And A Blue Surface), • The Slope Of The Route Related To Its The Length (Longitudinal Inclination Of The Sidewalk) Or An Independent Pedestrian Route Should Not Exceed 5%.5. The Detailed Scope Of Works, Apart From The Description Of The Subject Of The Order, Is Specified In: Annex No. 10: Functional And Utility Program;
|
