The Subject Of The Order Is The Delivery Of A Brand New (Production Year 2024) From Series Production (The Delivery Of Prototypes Or The First Devices In A Given Series Is Not Allowed), A Specialized Truck With A Gantry Body Equipped With A Snow Plow. A Detailed Description Of The Subject Of The Order, As Well As The Technical Specification Is Described In Detail In Annex No. 2 To Swz (Opz). Basic Requirements Of The Vehicle Chassis: 1) Gvw Min. 18 Tons,2) Wheelbase In The Range Of 3900-4000 Mm, Rear Overhang In The Range Of 1.25 M To 1.5 M,3) Steering Wheel - Left Side,4) Drive System Of The Vehicle 4X2.5) Vehicle Suspension: Front – Spring (Reinforced, At Least 3 Springs) And Rear – Pneumatic (Drive Axle On Two Or Four Airbags),6) Engine With Min. 280 Hp,7) Engine Displacement: Not Less Than 9000 Cm3,8) Differential Lock,9) Automatic Or Automated Gearbox, Without Clutch Pedal, 10) Fuel Tank With A Capacity Of Min. 200 Liters,11) Pto Adapted To The Planned Vehicle Structure,12) Lubrication Points (Applies Only To The Chassis),13) Chassis Compatible With Other Required Equipment, In Particular In Terms Of Vehicle Weight For The Installation Of The Gantry System And Assembly Of The Front End For The Snow Plow Along With Preparation Of The Installation For The Plows Driving Lights, Basic Requirements Of The Vehicle Body: 1) Guaranteed Support For Containers Type Kp5-Kp10; Mulda,2) Central Lubrication System Of The Body, Including Min. 14 Lubrication Points,3) Device Controlled From The Cabin/External Panel Or Remote Control,4) Hydraulically Telescopic Lifting Arms With A Reach Of At Least 4,330 Mm, Independently Controlled (Asynchronous);5) At Least 2 Emptying/Attaching Hooks; Internal Spacing Of Hooks In The Range Of 720-760 Mm + Additional Chains For Emptying Containers, Basic Requirements Of A Snow Plow: 1) Mounting On A Mounting/Front Plate For A Truck, 2) Plastic Moldboard, Height Min. 1 M,3) Two Replacement Blades Used Depending On Weather Conditions And The Type Of Snow Being Fought: Steel (Min. Hardox 400 Or Other With A Nominal Hardness Of 400 Hbw) And Rubber; Ability To Change Blades While Driving Required,4) Plow Width: 3.0 - 3.2 [M],5) Snow Removal Width (Plow In 30-Degree Position) - 2.6 - 2.8 [M],6) Protection Against Road Obstacles During Snow Removal (Plow In Working Position) Via A Spring Anti-Collision Mechanism, Other Requirements: 1) The Vehicle Must Have The Necessary Equipment And Documents Allowing It To Be Road Traffic In Poland And Enabling Its Registration And Operation Immediately After Receipt By The Ordering Party. In Particular, An Approval Certificate Will Be Required For The Vehicle Completed With The Bodywork Or The So-Called Partial Approval.2) The Delivery Includes Delivery Together With Technical Tests And Operation Training - Up To 6 People.3) Individual Driver Coaching - Independent Of The Training Provided Upon Receipt, Carried Out To Support Safe And Economical Driving Of Drivers. Detailed Description Of The Subject Of The Order, As Well As The Technical Specification Is Described In Detail In Annex 2 To The Swz (Opz).
|