Brita#3 - Granulometric Range: Minimum 60 Mm; Maximum 100 Mm; Clean Stone Without Residues., Rachão, Rock Up To 4.5 To 5 Originating From Sound Rock, Obtained Through The Crushing Process. With Excavation Service., Graded Crushed Base - Consists Of A Material With Well-Graded Granulometric Distribution, With A Maximum Diameter Of The Aggregates Not Exceeding 38 Mm And Fines Between 3 And 9% (Passing The No. 200 Sieve), Which Provides Good Interlocking Of A Solid Skeleton And Good Resistance, With Normally High Isc, Of The Order Of 60% To Greater Than 100%. The Mr Of These Bases Is On Average 100 To 400Mpa (1,000 To 4,000Kgf/Cm2), Depending On The Gradation, The Nature Of The Aggregates, The State Of Compaction And The State Of Tension, Especially With Regard To The Confining Tension. Aggregates Are Commonly Derived From Crushed Rocks And Must Typically Meet The Following Requirements: Health Of Coarse Aggregates = 15% And Fine = 18%, Los Angel Es La Abrasion = 50% And Sand Equivalent Ea ≫ 40% (Material Passing Sieve No. 4), Lamellarity = 20% (Ab Nt, 1991C; 1991F)., Crushed Powder - Material Passing Sieve 1/4´´., Crushed #0 Granulometric Range: - Minimum 06 Mm ; - Maximum 11 Mm; - Clean Stone Without Waste., 03/19/2024, 03/20/2024, Rough Detonated Stone, Minimum Ø 80Cm, Originating From Rocha Sã., Bica Corrida, For Primary Coating Of Unpaved Public Roads, Together With Excavation Services , Crushing. With The Following Granulometric Composition Specifications: - Gravel 18 To 21% - Coarse Sand 40 To 43% - Fine Sand 16 To 19% - Fine Material 17 To 20% Passing Through Sieve No. 200., Gravel - Material Passing Through Sieve 1/2, Brita#2 Granulometric Range: - Minimum 24 Mm; - Maximum 32 Mm; - Clean Stone Without Residues. Material Must Be Delivered To The Location To Be Indicated By The Department Of Works, Within The Limits Of The Municipality Of Brusque. Note: Shipping Of The Material Must Be Borne By The Supplier., Brita#1 Granulometric Range: Minimum 11 Mm Maximum 24 Mm; Clean Stone Without Residues, Fine Sand Technical Specification: - Chloride Content Less Than 0.1%; - Organic Matter Content Less Than 300 Ppm; - Clay Lumps Smaller Than 2%; - Powdery Material Content Less Than 1.0%; - Granulometric Composition Of The Medium Sand Located In Zone 2; - Table 1 Nbr 7211/1983., Coarse Sand Technical Specification: - Chloride Content Less Than 0.1%; - Organic Matter Content Less Than 300 Ppm; - Clay Lumps Smaller Than 2%; - Powdery Material Content Lower A1, 0%; Composition: Granulometric Of Medium Sand Located In Zone 4; - Table 1 Nbr 7211/1983., Sand Mixed With Crushed Stone For Concrete Composition Of 49% Crushed #0 And 51% Industrial Sand (Pedrisco)., Final Waste From Crushing And Grinding Limestone, Containing Calcium And Magnesium, Composed Of Medium Aggregates With The Following Granulometric Compositions: Brita 03, 15, 3 To 19, 2%, Brita 02, 11, 2 To 15, Brita 01, 29, 3 To 32, 2%, Brita 0, 24, 3 To 26, 5%, Medium Sand 5.5 To 7.2% And Fines 14.4 To 17.5%., Medium Sand - Technical Specification: - Chloride Content Less Than 0.0%; - Granulometric Composition Of The Medium Sand Located In Zone 3; - Table 1 Nbr 7211/1983. Note: All Material Must Be Delivered Dry, And Quantities Will Be Measured Using The Volume Measured In Each Truck Before Unloading. Landfill Material, Red Macadam, With The Following Granulometric Composition Specifications: - Boulder 42 To 45% - Coarse Sand 26 To 29% - Fine Sand 13 To 16% - Ma
|