Tall Closed Cabinet In Mdf 160X70x35cm, With 2 Lockable Doors And 4 Adjustable Internal Shelves. Made From 15Mm Mdf With A Color To Be Defined And Finished With Melamine Edge Tape And Tips, 2-Seat Service Counter With 15Mm Mdp Bp, Top With Wire Grommet And Edge Finish In Abs, Sides With Pvc Profile. Counter With Two Seats. Product Dimensions: Height: 121 Cm; Width: 205; E, Depth: 70 Cm, Single Bunk Bed Structure: Certified Reforested Wood (Cannot Be Particleboard Or Plywood). With Safety Rail On The Upper Bed; With Wooden Footrest And Headboard. Removable Ladder With Minimum 03 Steps. With Solid Eucalyptus Wood Platforms, Non-Removable (Fitted And Screwed), With A Minimum Thickness Of 2 Cm And A Width Of 6 Cm, Maximum Wood Spacing Of 7 Cm. Minimum Capacity Of 100 Kg. Approximate Dimensions (May Vary ± 15Cm): Width: 90Cm, Height: 2.02Cm, Depth: 200Cm, Minimum Distance Between Beds 90Cm. Sanding Finish And Coating With Polyurethane Varnish., Chest Of Drawers Made Of Mdp Or Mdf Material With 5 Drawers, Measures 90 Cm Wide X 50 Cm Deep X 73 Widths, 2 Upper 8Cm Height X 41 Depth X 31 Width. With Legs, In Mdp, In Light Gray Color, Office Table In Mdf Straight Office Table, With Measurements Of Width 1.80 Suspended, 100% Mdf, With A Top Of 25 Mm Or Higher, Other Parts Of 18 Mm Or Higher And Drawers Of 15 Mm, Bearing Telescopic Slides, With Panel Feet And Leveling Shoes. The Product Must Be Assembled By The Contractor, Color: To Be Defined, Shelf With Mdp Support, Measurement 25X90cm, Red Color, Stackable University Desk With Collapsible Clipboard Chair With Clipboard In High Impact Thermoplastic Resin Adult Size. Side Drawing Board For Right- Or Left-Handed Use In Abs Thermoplastic Resin, Capable Of Holding A Sheet Of A4 Paper Horizontally/Vertical, Equipped With A Pencil Holder In A Vertical Position With The Capacity To Store 5 Pencils Or Pens. Plank Measuring Approximately 560 Of The Chair By Means Of Screws Allowing The Use Only Of The Chair And/Or The Chair With Clipboard, And Without French Hands. Leaving The Space Of The Users Legs Free. “U” Shaped Feet Allowing Stacking When Detaching The Clipboard. Seat And Back In Virgin Polypropylene Plastic Resin, Manufactured Using The Thermoplastic Injection Process, With A Minimum Thickness Of 4Mm. Seat With Minimum Dimensions Of 400Mm Wide And 420Mm Deep. Backrest With Minimum Dimensions Of 400 Mm Wide And 200 Mm Deep, Equipped With Molded Reinforcement To Facilitate Movement Of The Chair, Fixed Using Screws. Embossed Manufacturers Mark Must Be On The Backrest. Seat/Floor Height 460Mm Approximately. Book Holder Made Of High Impact Thermoplastic Resin, Polypropylene, Closed On The Sides..., Childrens School Set Size 01 Consisting Of Chair And Wallet. Wallet With Time In Virgin Abs, Free From Mineral Fillers And Injection
|